• In 2020 Smith Outfitters acquired its 07 manufacturing license
• In 2021 Smith Outfitters launched its own branded AR15 called the S15
• In 2024 Smith Outfitters launched its own branded AR10 called the S10 

The S15 or S10 comes as a stripped lower to a fully built firearm, can be completely customized with certain specced out parts or cerakote coated.

A little bit about our lowers

The S15 lowers and uppers start off as a 7075-T6 Cerro Forging and then are milled. From here they are engraved and ready for cerakote or are anodized. (disclaimer- We have had a couple of different anodize companies over the years so there has been some slight variations of the colors and hardness levels).

All anodizing is now a MIL-A-8625, Type III, Class 2 black finish.

We are now on Gen 2 of the lower receivers where we have added small improvements like:

• Threaded Bolt Catch Roll Pin – Allows for simple installation of the bolt catch and virtually eliminates the chance to damage the finish during installation (pin included). 1/16″ Hex Key required for assembly.
• Upper Tension Screw – Allows users to fine tune the fit of the upper and lower receiver using a nylon tipped tensioning set screw inserted in the grip tang of the lower receiver. This provides a tight fit with any standard AR15 upper receiver.
• Threaded Takedown Pin Detent Recess – Allows users to easily install the Takedown Pin detent and spring with the use of a 4-40 set screw (no more launching detents across the room).

The S10 lowers and uppers are machined from 7075-T6 aircraft grade billet aluminum, tumbled in ceramic media and get blasted ready for coating. Can be sent off for anodizing or cerakote coated in house.

Our Billet S10 matching upper specs:

• DPMS Low Rail Height Spec
• Compatible with all standard DPMS .308 components and most aftermarket parts
• Accepts any MILSPEC .308 dust cover and forward assist