S15 Stripped Lower – Anodized Brown

Smith Outfitters S15 Stripped Lowers – Anodized Brown

The S15 lowers and uppers start off as a 7075-T6 Cerro Forging and then are milled. From here they are engraved and ready for cerakote or are anodized. (disclaimer- We have had a couple of different anodize companies over the years so there has been some slight variations of the colors and hardness levels).

All anodizing is brown finish

We are now on Gen 2 of the lower receivers where we have added small improvements like:

• Threaded Bolt Catch Roll Pin – Allows for simple installation of the bolt catch and virtually eliminates the chance to damage the finish during installation (pin included). 1/16″ Hex Key required for assembly.
• Upper Tension Screw – Allows users to fine tune the fit of the upper and lower receiver using a nylon tipped tensioning set screw inserted in the grip tang of the lower receiver. This provides a tight fit with any standard AR15 upper receiver.
• Threaded Takedown Pin Detent Recess – Allows users to easily install the Takedown Pin detent and spring with the use of a 4-40 set screw (no more launching detents across the room).

$115